25
AlphaCom XE - Installation, Configuration & Operation
A100K10805
Click
●
Save
to save the values
Do
L
NOT
click
Apply
until all address, routing and filter changes as
described in sections 3.4.2, 3.4.3 and 3.4.4 have been saved!
Configure IP routing
3.4.3
The IP Routing table of AlphaCom must be configured if there is a
need to communicate with a device outside its own subnet. A “device”
could be another AlphaCom, a PC (AlphaPro, AlphaWeb, SysLog), SIP
gateway, etc. If AlphaCom and the device belong to the same subnet,
there is no need to specify any routing information.
Route types
Route type
Host
is used to set up a route to a single device outside the
subnet of AlphaCom.
Route type
Net
is used to set up a route to another network.
Route type
Default
is used to set up a general route to any device
outside the subnet of AlphaCom.
Select
●
System Configuration
>
Routes
Select the type of IP route by clicking
●
Add Route
Default IP route
-
Enter only
Gateway
(IP address) and
Out Interface
Ethernet port (eth0/1)
Network route
-
Enter
Destination IP
address,
Destination
Mask
,
Gateway
and
Out
Interface
Ethernet port (eth0/1)
Host route
-
Enter
Destination IP
address,
Gateway
and
Out Interface
Ethernet port (eth0/1)
3.4.4
Internal firewall
AlphaCom XE has an internal firewall
allowing the network administrator to
open and close IP services that accesses
the AlphaCom XE from the different
networks. By default, the AlphaCom XE
comes with the most restrictive firewall
settings.
Select
●
System Configuration
>
Filters
Select the protocols that should be
●
allowed for each Ethernet port by
clicking the relevant checkboxes
Eth0
and
Eth1
If you want other protocols to be
●
allowed, click
Add Filter
to add a
new protocol to the filter table:
- Enter the
Protocol Name
- Select protocol type -
TCP/UDP
- Enter the port number -
Port (Lo:Hi)
Click
●
Apply
when all addresses,
routing and filter changes as
described in sections 3.4.2, 3.4.3
and 3.4.4 have been saved!
AlphaCom XE should now be connected to your IP network.
