StarTrac 263-4WD-8G-STAGE-V, Руководство пользователя

Страница: 68 / 100

68 | P a g e
OWNER’S MANUAL | STARTRAC 263 4WD – 8G – STAGE – V
5.28 REPLACEMENT OF TRANSMISSION, REAR FINAL DRIVES AND
POWER LIFT HYDRAULIC CIRCUITS OIL
1. Lower the lift arms to the ground.
2. Remove the plugs located at LH side of lower portion
of brake housing to make oil draining easier.
3. Place vessel under all drain plugs of transmission
housing to collect the oil as it drains out.
4. Remove the plugs and drain out the oil. Clean the
plugs and fit back on.
NOTE: When draining out and filling oil and checking oil
level, take care that the transmission is in horizontal
position.
FILLING UP THE TRANSMISSION
1. Fill up the transmission to the maximum level mark on
the dipstick.
2. Put the gearshift lever in neutral and start the Engine.
3. Let it run on idle until the oil reaches a temperature
over 25°c.
4. Check that the transmission oil reaches the required
level mark on the dipstick.
5. If required, fill up to the correct level.
See the Lubricants and Fuel chart ' for the type
of oil to be used according to the transmission type.
NOTE : If implements are used that require a great quantity of oil, make sure that the
transmission contains enough oil for every work condition. Top up as required. Let the oil
stabilize before checking its level.
5.29 RADIATOR DRAINING & FLUSHING (WHEN
COLD)
1. Remove the radiator cap and drain plug (A).
2. Let the coolant drain out. Close drain cock and plugs.
3. Flush the cooling system with water / Cleaning Solution for
15 minutes, then drain the cleaning solution.
4. Refit the drain plug and refill the coolant (Mixture of water,
anti-scaling agent, antifreeze).
5. Run the engine with radiator cap open and accelerate 2-3
times and Top up coolant if required.
6. Refit the radiator cap and ensure tightness all the
connections for any leakage.
NEVER remove the radiator cap when the engine is hot.
Fig.5.15
Fig.5.16
Fig.5.17