StarTrac 263-4WD-8G-STAGE-V, Руководство пользователя

Страница: 45 / 100

45 | P a g e
OWNER’S MANUAL | STARTRAC 263 4WD – 8G – STAGE – V
CHAPTER -4 OPERATION
4.1 BOARDING THE TRACTOR
Always board the tractor from left hand side where a footrest is provided while taking care the
other part of body must not foul with levers. This will provide ease to operator.
4.2 LEAVING THE TRACTOR
After stopping the tractor, leave the tractor from preferably from the LH side of tractor
4.3 STARTING THE ENGINE (IN SAFETY MODE – NEUTRAL POSITION
ONLY)
A - Check that, the gearshift lever is in neutral position.
B - Move the low/medium/high speed selector lever to neutral position.
C - Move the PTO lever to neutral position.
D - Rotate the ignition key clockwise and release it after the tractor starts.
E - Release the hand brake.
MAKE SURE THAT THE STARTING SYSTEM ALLOWS THE ENGINE TO START ONLY
WHEN THE LOW/MEDIUM/HIGH SELECTOR LEVER ARE IN THE NEUTRAL POSITION. IF
THIS FAILS TO OCCUR, HAVE THE TRACTOR REPAIRED BY YOUR DEALER OR
AUTHORIZED SERVICE CENTER.
4.4 COLD WEATHER STARTING (TEMPERATURES BELOW 0°C OR 32°F)
•
Perform operations A, B & C as instructed above.
•
Turn the ignition key to the “ ON ” position and keep it there for
maximum 5 - 8 seconds.
•
Turn the ignition key to the “START” position and start the engine.
•
If the engine fails to start within 10 seconds, return the key to the
“ STOP ” position.
•
Again, turn the ignition key to the “ON” position and keep it there for
maximum 5 - 8 seconds.
•
Turn the ignition key to the “START” position and start the engine.
NOTE:
•
Do not keep the key turned to the start position for more than 5 – 8 seconds at a time.
•
Wait at least 1 minute after every two failed attempts of starting the tractor.
•
If the engine does not start regularly and easily, do not continue as for you may run down
the battery. Bleed any air that may have accumulated in the fuel system and, if the problem
persists, check that:
1.
The fuel filters are not blocked.
2.
The battery and starter motor are efficient/ Working Fine.
Fig.4.1