StarTrac 263-4WD-8G-STAGE-V, Руководство пользователя

Страница: 49 / 100

49 | P a g e
OWNER’S MANUAL | STARTRAC 263 4WD – 8G – STAGE – V
4.15 PTO (POWER TAKE OFF) lever
•
The tractor is equipped with a Direct power take off that complies
with international regulations.
•
It is installed at the rear of the transmission housing.
•
PTO shaft has standard 6 Spline. PTO can be engaged or
disengaged by PTO shifter lever.
•
Two speeds can be obtained by putting the PTO Lever in 2
different position (i.e.540 and 1000).
Lever Position PTO Speed Engine RPM
540 540 2300
N - -
1000 1000 2305
4.16 PRECAUTIONS WHEN USING THE PTO
PTO shafts and implements operated by means of the PTO can
be extremely dangerous. It is therefore advisable to comply
with the following important instructions:
1.
NEVER operate without the PTO cover (Fig.4-9). These parts
protect Persons from injuries and the shaft splines from
damage.
2. Before connecting adjusting or working on implements
operated by the PTO, disengage the PTO, stop the engine,
remove the key from the dashboard and engage the
parking brake.
3. Do not work under raised implements.
4. Check to make sure that all implements operated by the
PTO are fitted with the correct protections, are in a good condition and comply with the
provisions established by law.
5. Before driving an implement through the PTO, ALWAYS make sure that all bystanders are
well away from the tractor.
6. Fix the drawbar in the central position when using implements that are driven by the PTO of
the tractor.
7. When using the PTO drive with a stationary tractor, ALWAYS make sure that the gears are in
neutral and that the parking brake is applied.
8. Before starting up any PTO- driven implement hitched to the three-point linkage, lift the
implement to its full height using position control and check that at least 1/4 of the total
length of the telescopic section of the drive shaft is engaged.
Fig.4.8
Fig.4.9