Instruction manual
5
Installation
Install the Network Switch onto a Wall
The mounting holes on the network switch are 8 mm in diameter, and the
distance between the two holes is 133 mm.
1.
Hold the network switch against the wall in the area that you want to install
it, and use a pencil to trace the location of the four
Mounting Holes
onto the
wall.
2.
Use the
Mounting Holes
that you traced on the wall as a template and drill
holes in the wall.
3.
Insert the four
Screw Anchors
into the holes.
Note:
Make sure that the
Screw Anchors
are flush against the wall.
4.
Place the network switch against the wall and insert the four
screws
through
the
Mounting Holes
on the switch and into the
Screw Anchors
. (
Figure 1
)
5.
Tighten the
Screws
.
Screw
Screw anchor
Mounting hole
Figure 1
*actual product may vary from illustration
