Instruction Manual
111
Adding an IP Source Guard Static Binding Entry
1.
On the
IP Source Guard Binding Table Status
page, select the port you want to
apply the IP Source Guard Binding Table Settings to.
2.
Enter a
VLAN IP
Address.
3.
Enter a
MAC Address
.
4.
Enter an
IP Address
.
5. Click the
Add
button
.
Viewing IP Source Binding Table Status
•
On the
IP Source Guard Binding Table Status
page, the following information
will be displayed:
•
Port:
Displays the port that the Source Binding applies to.
•
VLAN:
The port's VLAN IP address.
•
MAC Address:
The port's MAC address.
•
IP Address:
The port's IP address.
•
Type:
Displays the port's entry type.
•
Lease Time:
Displays the lease time.
•
Action:
Select the Delete button to delete the corresponding IP Source
Binding table setup.
Deleting an IP Source Guard Static Binding Entry
•
On the I
P Source Binding Table Status
page, select the
Delete
button next to
the corresponding IP Source Guard Static Binding set up you want to delete.
Port Security
This page allows you to configure the Port Security Limit Control system and port
settings. Limit Control allows for limiting the number of users on a given port. A
user is identified by a MAC address and VLAN ID. If Limit Control is enabled on a
port, the limit specifies the maximum number of users on the port. If this number
is exceeded, an action is taken. The action can be one of four different types as
described below.
The Limit Control module is one of the modules that utilize a lower-layer module
while the Port Security module manages MAC addresses learned on the port.
