Stanley AV 5, Инструкция по эксплуатации и обслуживанию, Страница: 11 / 314

ENGLISH ORIGINAL INSTRUCTION
10
4. OPERATING INSTRUCTIONS
4.1 TO INSTALL AN AVBOLT® FASTNER
For further information regarding this fastener, refer to the nose assembly data sheet as listed in the table on page no 7. The
information below is for guide use.
y
Check work and remove excessive gap. (Gap is the space between components of the Joint. Gap is excessive if
not enough pintail sticks through the collar for the nose assembly jaws to grab onto).
y
Put Avbolt
®
fastener into hole.
y
Push nose assembly onto the pin until the nose assembly anvil stops against the collar. Tool and nose assembly
must be held at right angles (90°) to the work.
y
Depress tool trigger switch to start installation cycle.
y
When the forward motion of the nose assembly anvil stops and the pintail breaks off , release the trigger. The
tool will go into its return stroke and push off the installed fastener. At the end of the return stroke the jaws will
partially release the expended pintail which can then be pushed through the jaws with the next installation and
then ejected through the rear of the tool.
y
Once the installed fastener has been ejected, the tool and nose assembly is ready for the next installation.
4.2 TO INSTALL AN AVDELOK ® FASTNER
For further information regarding this fastener, refer to the nose assembly data sheet as listed in the table on page no 7. The
information below is for guide use.
y
Check work and remove excessive gap. (Gap is the space between components of the Joint. Gap is excessive if
not enough pintail sticks through the collar for the nose assembly jaws to grab onto).
y
Put Avdelok ® fastener into hole.
y
Slide Avdelok ® collar over the pin. (The beveled end of the collar must be towards the nose assembly and tool.)
y
Push nose assembly onto the pin until the nose assembly anvil stops against the collar. Tool and nose assembly
must be held at right angles (90°) to the work.
y
Depress tool trigger switch to start installation cycle.
y
When the forward motion of the nose assembly anvil stops and the pintail breaks off , release the trigger. The
tool will go into its return stroke and push off the installed fastener. At the end of the return stroke the jaws will
partially release the expended pintail which can then be pushed through the jaws with the next installation and
then ejected through the rear of the tool.
y
Once the installed fastener been ejected, the tool and nose assembly is ready for the next installation.
CAUTION - DO NOT ATTEMPT TO BREAK OFF A PINTAIL WITHOUT THE INSTALLATION OF A COLLAR AS THIS WILL
CAUSE THE UNSECURED PORTION OF THE AVDELOK
®
OR AVBOLT
®
PINTAIL TO EJECT FROM THE NOSE AT A HIGH
SPEED AND FORCE.