9
OPERATING INSTRUCTIONS
There are 3 programmable times & temperatures, and 1 manual override time & temperature setting.
The timing range of all keys is from: 01 second to
99
hours (automatically switches from min/sec. to
hour/min). Each key is also programmable for one hold time and a two-position fan (on/pulse).
In normal operating mode, the READY LIGHT (LED) will illuminate when the oven temperature is +20°F
of set temperature. The HEAT LIGHT (LED) will illuminate when actual temperature is below set
temperature and the unit is calling for heat.
Once set and actual temperatures are equal, key 1, 2, 3 or M may be pressed. The light above the
corresponding key will be lit. Pressing the START key will begin a flex time countdown (time is
compensating) depending on temperature.
OPTIONAL STEAM INJECTION
The solenoid valve for steam injection is mounted behind the service panel on the right hand side of the
unit on COC-E and on back of the unit on C011 -E/G. The electronic timer is pre-set at the factory and
may be adjusted by operator if required for shorter or longer steam burst. For steam injection, press the
steam injection switch.
OVEN COOLDOWN
To cool down the oven to a lower desired temperature, follow the steps detailed below: Open the oven
door(s). Turn selector switch to "Oven Cool Down" position. Fan will now operate and cool down the
oven. When the oven has cooled to the desired temperature, turn the selector switch to the "0" position.
OPERATING NOTES
When the oven is turned on it will automatically preheat to set temperature if the door is closed. If the
door is opened while program is running, the cook cycle will pause and the display will flash. When the
door is closed, the display will return to the count down from where it was paused.
STARTING A COOK CYCLE
To start a cook cycle
, simply turn selector switch to
LO
or
HI
position and press the product
key for the product you wish to cook. If the product key is programmed, the correct cooking
time will be displayed
12:00
(example). Press the START key and the time will immediately
start to count down in minutes and seconds. If: 00 is displayed immediately and the unit starts to signal,
the key being operated is not programmed. If correctly programmed, it will count down to :
00
. When
zero is reached, the light above the product key will be flashing, the controller will emit an audible alarm
and immediately begin counting up (if programmed for a hold time).
Cancel this alarm by pressing the stop key; controller will continue to count up.
HOLDING TIMERS
If the unit is programmed with a holding time, the holding time will automatically start counting upon
expiration of the cooking cycle. When there is an active hold time, the HOLD indicator will be lit and the
light above the product key with the hold time will be flashing.
To cancel, press the
key.