10
DISPLAY DESCRIPTIONS
The unit is in the Operating Mode. The actual temperature is shown in the display and is
within 20 degrees of the programmed temperature.
The unit is in the Operating Mode. The actual temperature will flash in the display and is
more than 20 degrees below the programmed temperature range.
The unit is in the Operating Mode. The flashing display signifies a cook cycle has just been
completed.
The unit is in the Operating Mode. With three zeros displayed, the probe has failed, or the
appliance has gone beyond operating temperature. Shut the appliance OFF immediately
and call a technician.
CONTROLLER FEATURES
Fahrenheit or Celsius Temperature Display
The operator is allowed to configure the controller to display the temperature in degrees Fahrenheit or
Celsius from the jumper on the back of the circuit board (J3). By default, the unit is shipped from the
factory in Fahrenheit (J3 not shorted), unless otherwise specified by the customer. For Celsius display,
power unit down, remove jumper from Pin 1 and short both pins. When power is re-applied, the
controller will be in Celsius operation.
Programmable Times
The operator will have the ability to
program the cook times for each product
key. The controller is programmable in
minutes (up to 59) and seconds (up to
59), then hours (up to 99).
Programmable Temperatures
The operator will be able to program
cook temperatures for each product key.
The valid temperature range is 150 to
550°F (66 to 288°C).
Programmable Hold
The operator will be able to program each product key for a counting hold time and temperature
(140 to 200°F/60 to 94°C) or disable the hold mode.
HOLD LIGHT (LED) ON = hold mode enabled
HOLD LIGHT (LED) OFF = hold mode disabled.
Programmable Fan
The operator will be able to program each product key for one of two fan modes.
FAN LIGHT (LED) ON = Fan always ON
FAN LIGHT (LED) Flashing = Fan pulsed
Flashing Display
The temperature display will flash after every product key is pressed. The display will continue to flash
until the actual temperature is within 20° of set temperature.