SpinetiX HMP series, Техническая документация инструкция

Страница: 28 / 42

<time-manual>
<time>15:43:00</time>
<date>21-02-2015</date>
</time-manual>
Configure the device to use NTP configuration. When using this command, at least one NTP server
must be configured.
This command is composed of the following parameters.

<boot-delay>
Additional delay in starting up the device, ensuring that the NTP servers are running
before the device boots. The allowed values are: 0, 90, 120, 150, which is the delay
expressed in seconds.

<server-1> ... <server-5>
IP address of the NTP server used by the device. Note that only
<server-1>
is
compulsory, the other ones are optional.

<monitor-only-1> ... <monitor-only-5>
Indicates whether the server is used for synchronization, or if it is only watched for
statistics.
Note: this parameter will override settings done using
<time-manual>
.
For instance, to set up the default NTP configuration of the HMP, use:
<time-ntp>
<boot-delay>0</boot-delay>
<server-1>0.pool.ntp.org</server-1>
<server-2>1.pool.ntp.org</server-2>
<server-3>2.pool.ntp.org</server-3>
<server-4>3.pool.ntp.org</server-4>
<server-5>pool.ntp.org</server-5>
<monitor-only-1>no</monitor-only-1>
<monitor-only-2>no</monitor-only-2>
<monitor-only-3>no</monitor-only-3>
<monitor-only-4>no</monitor-only-4>
<monitor-only-5>no</monitor-only-5>
</time-ntp>
To set up a slave device to watch a master HMP using its IP address, use: