SpinetiX HMP series, Техническая документация инструкция

Страница: 38 / 42

For instance, to set up the device to use the internal file to control a Panasonic Plasma monitor, use:
<protocol-system>panasonic_plasma_ps.fsm</protocol-system>
Added in 3.1.0 firmware release.
Remove all FSM files that are present on the device.
If you want to ensure that a given set of FSM files are available and only this set, you must proceed in
two steps. In the first step, apply a configuration backup with the
<protocol-file-reset/>
. In the
second step, upload the new FSM file in the configuration backup.
For instance, to remove all certificates from the device, use:
<protocol-file-reset></protocol-file-reset>
Modified in 3.0.0 firmware release.
Select a custom FSM file as the active protocol file of the device. The protocols files can be uploaded
to the device as part of the compressed backup file. The protocol file selected by this command must
either already be on the device, or uploaded as part of the configuration backup, otherwise the setting
will not be applied.
Note: this parameter will override settings done using
<protocol-disabled>, <protocol-system>
or
<protocol-file>
.
For instance, to enable a "sample" protocol file (which can be created using the tool available at
http://www.spinetix.com/support/fsm ), use:
<protocol-file>sample.fsm</protocol-file>
Controls the settings of the serial port, or reset them to their default values.
This command can be used without any parameters to reset all the settings to their default value, or
with the following list of parameters:

<enabled>
Explicitly enable or disable the com port. If set to no the other options are ignored. If
not present or set to yes , the com port is enabled.

<baud-rate>