SpinetiX HMP series, Техническая документация инструкция

Страница: 33 / 42

Since firmware 3.1.1 the value 'XX:00' is also accepted for an hourly
pull of the project at minute 0.

<logs>
Parameters for the logs to be pushed by the device. It must include the following inner
parameters:

<log-source>
Destination URI where the log must be uploaded. The server must be
a WebDAV enabled server.

<log-time>
Time of the day at which the log are uploaded to the server. The
time is expressed as HH:MM. If not specified '00:30' is used.

<log-type>
Type of log to upload, from. Possible values are “accounting” (i.e.
upload the accounting log from the previous day) or “alllogs” (i.e. all
logs). The latter is the default value.

<rpc> (
Added in 3.0.0 firmware release.)
Parameters for the RPC concentrator to be used by the device. It must include the
following inner parameters:

<uri>
URI of the RPC concentrator.

<pooling>
Frequency at which the player will send the ready notification to the
server. If not specified '60s' is used.

<notification-only>
If set to 'yes', the player will not accept RPC calls, but will still send
the
ready()
notification at each polling interval. If not specified 'no'
is used.
Note: this parameter will override settings done using
<pull-mode-disabled>, <pull-mode-
static>, <pull-mode-file>
or
<pull-mode-remote>
.
Configure the player to pull a project from a WebDAV enabled server, without uploading logs.
<pull-mode-static>
<push-logs>no</push-logs>
<pull-project>yes</pull-project>
<project>
<project-
source>http://demo.spinetix.com/pullmode/SpinetiX_Hotel.xml</project-
source>
<project-time>12:30</project-time>
</project>
</pull-mode-static>
Configure the player to pull a hypermedia project from an HTTP server using an xml file to describe the
content. Logs are uploaded to a WebDAV server.