Added in 3.1.0 firmware release.
Controls whether the player shall output audio or not when the screen is in power save. If set to
yes
,
no audio will be decoded when the screen is power off using RS232 or the power save feature of the
device. This setting is disabled by default on all players.
The possible values are: yes, no.
For instance, to disable audio output when the screen is in power save, use:
<audio-power-save>yes</enable-audio>
Added in 3.0.0 firmware release.
Controls the splash image used by the device when booting, restarting or updating the firmware. This
commands can be used to set new images or the reset the images to the default values. If new images
are set, then they must be provided as part of the restored backup.
This command takes two parameters:
<name>
Name of the splash image to update. Possible values are 'boot', 'shutdown' or
'firmware.
<file>
Name of the file to be used as splash screen. This file must be present in the
compressed backup. If this parameters is omitted or the file is not found, the default
splash screen image will be used.
Note that it is not possible to set new splash screen images using RPC. It is however possible to reset
the default splash images using RPC.
For instance, to reset the shutdown image to the default file, use:
<splash>
<name>shutdown</name>
</splash>
For instance, to set the boot image to a jpeg image called 'splah.jpg' present in the configuration
backup file, use:
Содержание HMP series
Страница 1: ...www spinetix com ...
