Specac Atlas Power 15Ton, Руководство пользователя

Страница: 53 / 84

Atlas™ Autotouch 8T, 15T and 25T Hydraulic Presses
51
Option Screen (Opt) Status Conditions
On the blue coloured background area, the (
Opt ) screen also shows
the status conditions of the press for the Pump Temp . (motor/pump
temperature), and the Pressure Cal. (pressure calibration) factor. The
values shown are display parameters only and cannot be changed.
Pump Temp. - If the motor/pump temperature reaches approximately
55°C, the press will be inactivated for pumping a load. A warning
message “
Pump Too Hot !” will be displayed on the screen. Only when
the pump cools down sufficiently will the message disappear and the
press can be used again to apply a load. If the press motor/pump
continues to overheat, please contact Specac for advice.
Pressure Cal. – A typical value shown (circa 1.090) is a factory set
calibration factor for load application readings that is a standard factor
for any Autotouch press variant (8T, 15T, 25T).
3) Programming Screen ( Pgm )
If it is a requirement to operate the Atlas™ Autotouch 8T/15T/25T
press just for a simple set load application under a
maintain load
function for an unspecified time (an auto “top up” of the load is
operating) and a fast release function, then the Simple Operation
Program (
PZ ) is used. (This program is loaded as standard when the
press is initially powered up).
However, the Atlas™ Autotouch 8T/15T/25T press can be
programmed for a sequence of up to 10 (ten) segments (
S#’s ), to
create a particular sequence of events of set load applications
(
Maintain or Hold Load functions), specified hold times (from 0.1 up to
99.9 minutes as a defined hold time or indefinitely - infinity) and varying
load release rates. The maximum number of programs (
P#’s ) that can
be stored in the Atlas™ Autotouch 8T/15T/25T press is 6 (six) – ( P1 to
P6 ). (The ( PZ ) simple program is always stored and can never be
edited or overwritten).