Sony UP-971AD, Инструкция по эксплуатации

Страница: 12 / 46

Get
ting St
ar
te
d
Location and Function of Parts and Controls
12
Adjusts the contrast of printouts.
E
BRIGHT (brightness) dial (page 32)
Adjusts the brightness of the printouts.
F
CUT button (page 16, 28)
Press to cut the paper at the end of a print job using
the internal paper cutter.
While printing, press to cancel the print job.
G
FEED button (page 16, 28, 28)
Hold down to feed paper. While printing, press to
cancel the print job.
H
MULTI PICTURE (multi-picture) button
(page 29)
Toggles between the multi-picture mode and
single-picture mode.
Note
This function is available only when printing a
video image.
I
CAPTURE button (page 29, 34)
In the multi-picture mode, press to store the print
image in the memory of the unit.
When “STR:CAPT” is selected in the “STR.KEY”
menu, image data captured from the video signals is
stored in the USB Flash Drive.
Note
This function is available only when printing a
video image.
J
COPY button (page 30, 32)
Press to print a copy of the last printed image. Prints
only one paper regardless of the paper number set
in the “QTY” menu. This function is not available
in the multi-picture mode.
K
PRINT button (page 28, 34)
In the multi-picture mode, images stored in the
memory of the unit (by the CAPTURE button) are
printed sequentially on a single paper.
In the single-picture mode, press to print the image
displayed on the monitor. When you press the
PRINT button, the displayed image is stored in the
memory of the unit and printed.
When “STR:PRNT” is selected in the “STR.KEY”
menu, the image is stored in a USB Flash Drive
after printing
Note
This function is available only when printing a
video image.
L
OPEN/CLOSE button (page 15, 28, 37)
Press to open or close the paper door. While
printing, press to cancel the print job.
M
Paper door
Open to install or replace printing paper, and to
clean the thermal head and platen roller. Use the
OPEN/CLOSE button to open or close the paper
door.
N
USB Flash Drive terminal
Connect a USB Flash Drive to this terminal.
O
USB Flash Drive access lamp
Displays USB Flash Drive access status, or verifies
any non-compatible USB devices.
Rear Panel
A
Equipotential terminal
Used to connect to the equipotential plug to bring
the various parts of a system to the same potential.
Refer to “Important safeguards/notices for use in
the medical environments” on page 3.
B
t VIDEO IN (input) connector (BNC type)
Connect to the video output connector of video
equipment.
C
T VIDEO OUT (output) connector (BNC type)
Connect to the video input connector of a monitor,
etc.
Outputs the video signal which is input from the
VIDEO IN terminal (Automatic termination is
provided).
D
REMOTE connector (page 17, 30)
Connects the Remote commander RM-91 or Foot
switch FS-24 (separately sold) for controlling print
operation from a distance.
E
USB connector (4-pin connector)