Sony UP-971AD, Инструкция по эксплуатации

Страница: 28 / 46

O
per
a
tio
n
Printing
28
Printing
The difference between film printing and paper
printing
In film printing, images are printed from the top.
* When “BAC:AUTO” is set in “PREF,” “-BACWRD”
Film printing has a function which prints a margin in
black.
Before Starting a Print Job
Always check the following points:
• Unit connected correctly? (page 17)
• Paper loaded correctly? (page 15)
• Menu settings and menu adjustments done correctly?
(page 19)
• In the case of a video image, is the video source signal
input?
Starting a Print Job of Video
Images
You can set up the printing direction, image size, and
various settings for printing, using the menu. This
section describes operations after completing the
various settings using the menu.
1
Press the power on/off switch to turn the unit on.
The back light on the LCD lights in orange, and
then changes to green. “READY” is displayed on
the LCD.
2
Start the video source.
This operation is done using the controls of the
video equipment which you are using as the source.
3
Press the PRINT button when the image you want
to print is on the video monitor.
The image displayed at the instant you press the
button will be printed.
When a message is displayed on the LCD
If a problem occurs, the back light on the LCD will light
in amber and an error message stating the problem is
displayed on the LCD.
When the unit stops printing during printing
When continuously printing images of high density,
such as mostly dark images, the thermal head protection
circuit may shut down the unit to prevent the thermal
head from overheating. In such a case, the message
“COOLING” is displayed on the LCD.
Wait until the thermal head cools down and the message
disappears.
To cancel a print job in progress
To cancel a print job in progress, press the OPEN/
CLOSE button, FEED button or CUT button.
To feed paper
To feed paper, press the FEED button. The unit will
continue to feed paper as long as you hold down the
FEED button. Do not attempt to pull paper out of the
unit by hand.
Film print (UPT-210BL) Paper print (UPP-210HD,
UPP-210SE)
When “BD:BLACK”
is set in “PREF,”
“-BORDER” When “BD:WHITE”
is set in “PREF,”
“-BORDER”
Message Cause and remedy
EMPTY Paper is not loaded. Load paper.
DOOR The paper door is open. Close the
paper door.
LCD