Sony UP-971AD, Инструкция по эксплуатации

Страница: 15 / 46

Pre
par
at
ion
Loading Paper in the Unit
15
Preparation
Loading Paper in the
Unit
Caution
Do not touch any unit circuitry and the patient at the
same time.
If the unit malfunctions, it may generate voltage that
could be harmful to the patient.
Notes
• Do not touch the print surface of thermal printing
paper when loading it. Fingerprints, perspiration and
creases that may result will lower the print quality.
• Use only UPP-210 series or UPT-210BL printing
paper (page 38).
• If you use the UPP-210 series, set the menu according
to the paper (page 38).
1
Press the power on/off switch to turn the unit on.
The LCD display shows the message “SONY UP-
991AD” for the UP-991AD and “SONY UP-
971AD” for the UP-971AD.
Notes
• The LCD display backlight lights in amber and
shows the message “EMPTY” when no printing
paper is loaded.
• The LCD display backlight lights in amber and
shows the message “DOOR” when the paper door
is open.
2
Press the OPEN/CLOSE button to open the paper
door.
3
Place the printing paper roll on the tray.
Using UPP-210SE/UPP-210HD
Place the paper with the heat sensitive side facing
up. The printer will not print if the paper is
reversed.
Using UPT-210BL thermal film
*
Cannot be used with the UP-971AD. Doing so may
cause a malfunction.
Place the paper with the heat sensitive side facing
up. The printer will not print if the paper is
reversed.
Remove label
and pull out 15
to 20 cm (about
6 to 8 inches).
Remove label
and pull out
15 to 20 cm
(about 6 to 8
inches).
Correctly Inserted
Incorrectly Inserted