Connect Power
16
Cha
pte
r 2
P
rep
ar
at
ion
3
Use the supplied control panel cable to
connect the unit and the control panel.
4
Use the cable clamp as shown, to fix the
cable.
Note
Always turn off the power supply for the unit before
disconnecting the control panel cable and removing the
control panel.
To remove the control panel
Grasp the underside of the CP bracket and push it
in the
B
direction to release the lock. Then slide
the control panel out.
The SR-R1 can be powered either from a battery
pack or AC power.
For safety, do not use any AC adapter or battery
pack other than the Sony products specified
below.
• AC adapter: AC-DN10
• Lithium ion battery pack: BP-GL95
Tip
To use the battery pack, the Battery Adapter BKP-L551
(sold separately) is required.
Use the DC power cable (sold separately) to
connect the AC adapter AC-DN10 to the DC IN
connector on the SR-R1.
Note
When connecting the output of a battery to the DC IN
connector, access the SYSTEM Setup menu and set the
BATTERY >DC IN TYPE option to other than “AC
Adapter.”
Before using the battery pack, charge it fully with
the dedicated battery charger.
For detailed information on charging, refer to the
documentation of the battery charger.
WARNING
Batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey
the law in the relative area or country.
AVERTISSEMENT
N’exposez pas les batteries à une chaleur
excessive, au soleil ou près d’un feu par exemple.
Connect Power
Using AC Power
Using the Battery Pack
