Sonic KCS-3500, Руководство по эксплуатации

Страница: 67 / 102

7-5
Note 3) The tilt amounts of roll and pitch are displayed when the STB LED and X-Y LED are ON.
・
LED for Information
Silk Status (when the LED is turned ON)
PRC The communication with PRC is enabled
STB The inclinometer output is turned ON
HALF The half-round function is enabled
HAND The emergency manual handle is in use
PHASE There is a connection error or overload of the three-phase 220V
motor
MANU The manual mode is enabled
CENTER The turning amount is from 00 (hex) to F8 (hex) (to the right from
the center)
X-Y The tilt amount (roll angle and pitch angle) is displayed on the 7
segments
・
7-Segment LED Display
Hoist operation errors can be solved by investigating following status in most cases.
LED Status Description of status
C 00 01 The emergency manual handle is in use, or
the emergency stop switch is turned ON
Flashing Value The flashing value has reached its limit
E 00 01 A code setting error of the rotary switch
(the combination of the type and the stroke of the hoist unit is not
correct)
E 00 02 Communication is established because the computer is turned on in the
manual mode
E 01 01 The inclinometer (rolling) is disconnected
(* This can only be detected when the stabilizing function is enabled.)
E 01 02 The inclinometer (pitching) is disconnected
(* This can only be detected when the stabilizing function is enabled.)
E 01 03 The inclinometer is disconnected even with the stabilizing function is
enabled
E 02 01 There is a connection error or overload of the three-phase 220V motor
E 03 01 An installation error or a connection error of the repeater on the right
side
E 03 02 An installation error or a connection error of the repeater on the left side
E 03 03 An installation error or a reading error of the repeaters on the right and
left sides
E 03 04 The right and left wires of the repeater are oppositely connected
E 04 01 A turning operation error
E 04 02 A depression angle operation error