SOMFY Protexial, Руководство по установке

Страница: 46 / 56

Testing the installation
■
46
■
Press
Type the duress
code + siren
(must be stored in
menu 25)
Testing the entire system
Testing the phone dialer only
Fully arm the alarm and then leave the house.
To test for correct sending of an SMS to the 4 numbers stored: On the LCD keypad:
1 - Press OFF
2 - Enter the duress code, mute (should be stored in menu 24). The call cycle for sending the alarm message to the 4 phone
numbers starts.
3 - Stop the alarm message call cycle by pressing the OFF key on the remote control or OFF + user code 1 on the keypad.
To test for correct sending of an SMS by the fixed phone line, enter the following on the LCD keypad:
After the 2 minute exit delay , open all the doors and windows
that are equipped with opening detectors.
Move in front of at least one movement detector.
The sirens are triggered. Allow the sirens to ring for at least the
programmed telephone dial-up delay.
The phone dialer starts dialing.
The roller shutters come down and the lights come on if these
functions are programmed.
Disarm the alarm by pressing the OFF key on the remote control.
The call cycle stops with the exception of the current call.
Identify the detectors that triggered the alarm (see page 50).
Sous surveillance
Testing the detectors
With the alarm disarmed,
press the detector For a 2-minute period, the indicator on
the detector lights up on each detection
If a problem occurred during the test, refer to page 52,
Troubleshooting.
… BEEP! … BEEP!
Testing the sirens and the phone dialer
The sirens are activated for
2 minutes and the phone dialer
picks up the line
You can interrupt the sirens and
the call cycle by disarming the alarm.
To do this, press OFF on the remote
control or OFF + user code 1 on the
keypad.
Door opening/closing
Movement in front of the detector
For the outdoor movement detector, refer to the corresponding instructions.
3 x BEEP! ... 2 mins, BEEP!
or
3
Hold down the ON key until the
indicator goes off.
1
1
2
2
Sous surveillance Sous surveillance
Arm the alarm
The SMS sent will be “SMS sending test“.
The test will be sent to the 1
st
SMS number stored.
Sending test OK
2 3 3 OK
To test for correct sending of an SMS by GSM, enter the following on the LCD keypad:
The SMS sent will be “SMS sending test“. This test will be
sent to the 1
st
SMS number stored.
Sending test OK
2 4 3 OK