Fixing the devices
Water leakage
detector
1
Fix the sensor mount to the wall at floor level.
2
Mount the detector casing on the wall approximately
1m above the floor.
3
Slide the sensor between the mount’s lugs until you
hear a click, and pass the wire through the slots.
4
Leave the detector’s switches in the OFF position.
Close the cover again.
5
Test the detector:
Pour water between the sensor’s 2 electrodes.
The indoor siren sounds quietly for 2 minutes.
To stop the alarm, press the “OFF“ button on the remote control.
At the end of the test, remove the water and dry the electrodes.
D
ETECTOR
M
OUNT
S
ENSOR
If you want to control a motorised garage door or gate, it is essential to install
the keypad where you can see these automatic devices for safety reasons.
2
LCD keypad
This must be
inside the dwelling
. It is advisable to install it near the front door.
70 mm
BOTTOM
TOP
TOP
6
0
BOTTOM
1
Close
the product
again.
Affix the tamper strip firmly against the wall.
H
OLE IN
TAMPER STRIP
Ø 6 mm
2
Control keypad
This must be
inside the dwelling
. It is advisable to install it near the front door or inside
the garage.
51 mm
HAUT
HAUT
TOP
TOP
4
7
BAS
BAS
DOWN
DOWN
1
Close the
product
again.
Tighten the 2 screws
on the sides.
Tighten
the 2 screws
at the base of
the casing.
Affix the tamper strip firmly against the wall.
H
OLE IN
TAMPER STRIP
Ø 6 mm
■
19
■
