4 Using the PVA-600 Software
4-26
7.
To open an existing Model file, select
Browse…
in the
Model
menu, as shown in
Figure 32, then open a file using the
Open
dialog box.
Figure 32. Open a Model file
8.
If you need to set up a new model, refer to Setting Up a New Model.
9.
Turn on the I-V Measurement Unit by pressing the red power button shown in
Figure 33. The LED will begin to blink indicating that the PVA-600 is attempting to
establish communication with the wireless USB adapter connected to the PC. Once
communication is established, typically in less than 20 seconds, the
Measure Now
button will become active.
NOTE
If communication is not established within one minute:
a. Move the PC closer to the I-V Measurement Unit.
b. Reset the I-V Measurement Unit.
c. Remove and replace the Wireless USB Adapter.
Figure 33. Turn on the I-V Measurement Unit
10.
If you are using the PVA Sensor Kit to transmit the irradiance and temperature
wirelessly, refer to Setting Up the Optional PVA Sensor Kit for setup information
then perform the following:
a.
Click on the
Sensors
tab to access the screen shown in Figure 34.
Содержание PVA-600
Страница 1: ...Solmetric PVA 600 PV Analyzer User s Guide ...
Страница 10: ...x The page left blank intentionally ...
Страница 18: ...1 Introduction 1 8 The page left blank intentionally ...