solasfires.com
33
ASSEMBLY & INSTALLATION
Installing or Replacing the Batteries
1. The valve control module is powered by (4) “AA"
batteries. The batteries are mounted within the Valve
Receiver Module located on the right side of the fire-
place attached to a drop-down mounting bracket for
easy accessibility. Refer to the adjacent photo.
2. Loosen the thumb screw on the module drop-down
mounting bracket by turning counter-clockwise until
the threads are fully disengaged from the base bracket.
3. Rotate the Valve Receiver Module and mounting
bracket. Toward you 90°.
4. Slide off the Battery compartment cover.
5. Install the (4) “AA" batteries, supplied, using the guides
inside the battery pack to show you the correct battery
orientation.
6. Replace the battery compartment cover. Rotate the
Valve Receiver Module and mounting bracket into its
home position and tighten the thumb screw to secure.
7. The remote handset is powered by (2) “AAA"
batteries. The access panel is located on the back of
the handset and simply snaps open to provide access
to the battery compartment. Install the three batteries
as shown on the label inside the remote control battery
compartment.
8. Replace the remote handset access panel.
Placing the Burner Glass Media
The burner glass media poly bag that you set aside
when you unpacked the fireplace contains the correct
amount of glass material to cover the burner. The entire
contents of the bag should be evenly distributed over
the burner tray.
1. Locate the burner in the fireplace. Refer to the
adjacent photo.
2. Carefully clip one corner of the poly bag to form a
pouring spout. The opening should be large enough
to allow the glass media to flow but not so large that
you can’t control the flow.
3. You will notice that the burner surface is designed
with turned-up edges that form a tray to hold the
glass media.
Burner Tray
