Lit. No. 76616, Rev. 02
19
November 15, 2018
OPERATING AND CALIBRATION INSTRUCTIONS
Factory Defaults:
• BLAST Target Rate: 35
• BLAST Duration: 5 seconds
• Units: gal/acre
The control is also equipped with visual and
audio alarms. The alarms will trigger if the actual
application rate is above or below 10% of the
target rate. For more information on the alarms and
other control features see "Deluxe Console" in this
section.
2. To avoid draining the vehicle battery, turn the
control OFF when not in use.
3. When
fi
nished turn the motor OFF.
NOTE: The unit cannot automatically adjust the
application rate unless there is a compatible
speed sensor installed.
Manual Mode
NOTE: In this mode the control will not
compensate for speed.
1. During normal operation, set the rotary switch to
VOLUME/MINUTE to see the
fl
ow rate. This value
can adjusted using the Up (+) and Down (–) arrow
buttons on the control. Use the RUN/HOLD button
and the boom switches to control the boom as
desired.
Factory Defaults
• Units: gal/acre
2. To avoid draining the vehicle battery, turn the
control OFF when not in use.
3. When
fi
nished turn the motor OFF.
Standard Control
Follow the steps below to get started using your
standard control. See the Owner's Operating Manual
for the control for complete details and instructions.
1. Before spraying, consider what speed range
you wish to operate in, and select and install the
appropriate nozzles using the application rate
charts in this manual. Note that the unit will not
function as intended outside these ranges.
2. Set the master switch to OFF and turn the power
switch ON.
3. Set the valves to the spray con
fi
guration. Start the
Liqui Maxx™ sprayer's motor by turning the motor
ON, setting the appropriate choke, and pulling the
recoil start handle.
Spray Con
fi
guration:
• Brine Fill Valve: Closed
• Shut-Off Valve: Open
• Return Valve: Set pressure to 40 psi by
opening and adjusting return valve.
4. During normal operation, use the master switch
and boom switches to control the boom as
desired. Increase or decrease the pressure of the
system as desired using the pressure switch.
5. To avoid draining the vehicle battery, turn OFF the
control when not in use.
6. When
fi
nished turn the motor OFF.
