IQH3A IQ 3U Modular Enclosure
www.snellgroup.com
Safety Notices
Issue 2 Rev 2
Page 6
©
2014 Snell Limited
For Products With More Than One Power Supply Inlet
Rack Mounting the Enclosure
When rack-mounting the product, one of the following methods of installation must be used:
•
place the unit on a suitably specified, and installed rack shelf and secure the product
to the rack via the front rack ears or,
•
fit the unit using the rear rack mount kit available from Snell by quoting the order code
FGACK RACK-MNT-KIT.
Replacing the Gateway Card
If the Gateway Card IQRCIF is replaced ensure that the part number of the card is RCIF3U2C
to enable the chassis monitoring facility. If it is replaced by an earlier Gateway Card, e.g.
RCIF3U2B this will still offer full control of installed modules but will not enable the PSU and
chassis monitoring.
Safety Standards
The IQH3A Enclosure conforms to the following
standards:
EN60950-1: 2001
Safety of Information Technology Equipment.
UL Listed
Professional Video Equipment File No. E193966.
Laser Safety
This label is fitted in products indicating a laser
source conforming to the following standard:
EN60825-1 (2001)
Safety of Laser Products.
To reduce the risk of electric shock plug each power supply cord into separate branch
circuits employing separate service grounds.
This product must not be rack mounted using only the front rack ears.
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure. Viewing the laser diode with the optical
fiber removed and with the aid of optical magnifiers may be hazardous.
The IQ fiber module is a Class 1 laser product (output power <15 mW) at 1310 nm with a
beam divergence >30 mrad. The laser diode used is class 1 M (output power <30 mW).
