
User Manual
GW1160 - GW4060 Series
Page 33 - 75
fig. 22 – RESET: during the RESET the display shows “ P- “. At the end of the RESET cycle, “ E- “ appears on the display.
4.13
PRINTING THE CYCLE AND APPLIANCE PARAMETERS
If the Smeg “WD-PRINTE” accessory has been installed,
it is possible to force printing of the data relating:
1.
To the last cycle performed: by pressing the
1 On/Off
and
2 Functions
keys simultaneously.
2.
To the setup parameters, by pressing the
3 Functions
and
4 LH Selection
keys simultaneously.
Print last cycle
+
Print parameters
+
Commands are only accepted if the door of the device is closed.
1
2 - 3
4
fig.
23
– Standard procedure for forcing printing.
Last cycle
data: use “
On/Off
”+”
Functions
” keys;
Parameters:
use “Fun”LH Selection” keys.