User Manual
GW1160 - GW4060 Series
Page 21 - 75
4.5
SELECTING THE WASHING PROGRAMME
The device has an interface, with segment display and 10 LED-lit symbols, for user-device communications.
To run a program:
1.
Close the door by shutting it against the appliance until the lock clicks shut.
The buttons are only enabled
with the door closed.
2.
If the appliance is off, switch it on by pressing the
On/Off
key (hold down for 2 seconds)
3.
Use the
Selection
buttons to select the program.
4.
Once the selection has been made, the
Functions
button can be used to scroll through the program
parameters.
5.
Only for GW4060 series: If the program includes a drying phase, its duration can be adjusted using the
Drying
Decrease
and
Drying Increase
buttons.
6.
Press the
Start/Stop
button to start the cycle (hold it down for 2 seconds).
7.
Two beeps sound to indicate the start of the cycle.
8.
Once the selected program has been successfully completed, the display shows
End
“.
9.
Interrupting the cycle:
A cycle in progress can be interrupted by pressing the
Start/Stop
button.
A
After the cycle has been interrupted, the options available vary depending on conditions in the chamber:
i.
If the temperature in the chamber is below
40°C
: the door can be opened. If the door is
closed again within 1 minute, the cycle can be restarted from the phase where it was
interrupted by holding down the
Start/Stop
button.
ii.
If the temperature in the chamber is above 40°C: a reset cycle is required since the door
cannot be opened.
2
3
1
fig. 11 – Standard procedure for
starting a cycle.
1
Select the program
using the
Selection buttons.
2
Check the
program parameters:
Functions
button.
3
Start the program
: hold down the
Start/Stop button
.
CONTROL PANEL SYMBOLS
SYMBOL
MEANING
SYMBOL
MEANING
On/Off
Functions
Drying Decrease
(only for GW4060)
Drying Increase
(only for GW4060)
Start / Stop
Door opening
Selection
Selection