SMC Networks HRS090-A, Руководство по эксплуатации

Страница: 24 / 196

HRX-OM-S004
Chapter 3 Transport and Setting Up
3.2
Installation HRS Series
3-4
3.2 Installation
3.2.1 Environment
The product must not be operated, installed, stored or transported in the
following conditions. Potential malfunction or damage to the product may
occur if these instructions are disregarded.
The product is not designed for clean room. The pump and ventilating fan
inside the product generate particles.
z Location that is exposed to steam, salt water or oil.
z Location that is exposed to dust or powder material.
z Location that is exposed to corrosive gas, organic solvent, chemical
solution, or flammable gas (the product is not explosion-proof)
z
Location where the ambient temperature is out of the following range:
During transportation or storage: -15 to 50°C (No water or circulating fluid
in the piping.)
During operation: -5 to 45°C
z Location where condensation forms on the inside electrical parts.
z Location that is exposed to direct sunlight or heat radiation.
z Location that is near heat sources and poor in ventilation.
z
Location that is subjected to abrupt changes in temperature.
z Location that is subjected to strong electromagnetic noise (intense electric
field, intense magnetic field, or surges).
z Keep the product uplight on a rigid and flat floor which can resist
the weight of the product, and take measures to prevent the
product from tipping over. Improper installation may cause water
leakage, tipping, damage of the product or injure the operator.
z Keep the ambient temperature of the product between -5 to 45
o
C.
Operation out of this ambient temperature range may cause a
malfunction of the product. Operating the product in an
environment temperature of 45
o
C may reduce the heat
discharging efficiency of the heat exchanger and the safety device
may function, resulting in the product operation stoppage.
z The installer/end user is responsible for carrying
out a acoustic noise risk assessment on the equipment after
installation and taking appropriate measures as required.
Do not set up the product in places possibly exposed to leakage of
flammable gas. Should any flammable gas stay around the product,
the product may cause a fire.