SMAR LD303, Инструкция по эксплуатации и техническому обслуживанию

Страница: 37 / 110

Configuration
3.11
Using this window, the user can set the Primary Value Type according to his application, selecting
"Pressure" or “Flow".
Also, the user can select the Linearization Type, choosing "No Linearization", "Square Root" or
"User Defined (Table)”.
When the user desires to make the square root of pressure is necessary to set Primary Value Type
to "Flow".
Using the next window the user can configure the units according to the Transducer Block Diagram:
Figure 3.5 – Scale Units for Transducer Block
Table handling
There is the possibility to load and re-load tables in the devices. This table is used for linearization
mostly. For this procedure the following parameters are necessary:
TAB_INDEX
TAB_X_Y_VALUE
TAB_MIN_NUMBER
TAB_MAX_NUMBER
TAB_OP_CODE
TAB_STATUS
The TAB_X_Y_VALUE parameter contains the value couple of the each table entries.
The TAB_INDEX parameter identifies which element of the table is in the TAB_X_Y_VALUE
parameter currently (see the following figure).
The User can select the
output unit and output
scaling according to his
application.
The User can
select the
temperature unit.
The User can
select the unit
and scaling for
pressure.