LD303 - Operation and Maintenance Instruction Manual
1.8
Existing standards for the manifolds have also been taken into account, and standard designs fit
perfectly to the transmitter flanges.
Should the process fluid contain solids in suspension, install valves or rod-out fittings at regular
intervals to clean out the pipes.
The pipes should be internally cleaned by using steam or compressed air, or by draining the line
with the process fluid, before such lines are connected to the transmitter (blow-down). Do not allow
steam to enter the measuring chamber. Observe operating safety rules during wiring, draining or
blow-down
.
Some examples of installation, illustrating the position of the transmitter in relation to the taps, are
shown in Figure 1.3. The location of pressure taps and the relative position of the transmitter are
indicated in Table 1.1.
Process
Fluid
Location
of Taps
Best Location for the LD303 in
Relation to the Taps
Gas
Top or Side
Above the Taps
Liquid
Side
Below the Taps or at the Piping Centerline
Steam
Side
Below the Taps using Sealing (Condensate ) Pots
Table 1.1 - Location of Pressure Taps
WALL OR PANEL MOUNTING
(See section 5 – spare parts list for
mounting brackets available)
Figure 1.2 – Drawing Mounting of LD303 on the Panel or Wall
Figure 1.3 - Position of the Transmitter and Taps
Содержание LD303
