Translated by R.Whitehead 10-3-2014 (my best effort – accuracy is not guaranteed)
22 of 38
If a UniLog 1 / 2 or UniSens-E is attached to the GPS-Logger 2 and is read, the measured
values of the UniLog will also appear here. Values the UniLog 1 does not deliver remain free
i.e. on 0:
Top: Drive voltage, barometric altitude from starting point
Bottom: Drive current, capacity used
Top: energy used
Bottom: rpm, drive power
Top: Rx voltage, barometric altitude from starting point
Bottom: Vario as a numerical value
Top: Single cells 1 - 3
Bottom: Single cells 4
– 6
Top: Sensor value at port A1
Bottom: Sensor value at port A2
Top: Sensor value at port A3
Bottom: Servo impulse at the Rx connection, servo impulse
at the ESC connection
Top: current air pressure
Bottom: internal temperature of the UniLog 1 / 2.
10.1.3. Alarms
When operating on the Jeti transmitter modules, with the display of data on the simple
JetiBox, all alarms and also the Vario sounds are generated directly from GPS-Logger 2
All settings are also made on the GPS-Logger 2.
The Jetibox Profi and the Jeti transmitter can, in Jeti EX mode, generate alarms and Vario
tones themselves. These are then preset in the Box or transmitter. Alarms that are set in
GPS-Logger 2 remain as additional output.
H 23.28 v 221.8 m
36.04 A 1377 mAh
I 1750.1 Wmin
2481 rpm 839 W
J 5.01 VRx 221.8 m
+12.1 m / s
K 3.61 3.65 3.66
3.65 0.00 0.00
L A1 - - - -
°
C
A2 44.9
°
C
M A3 221.9 Km / h
1100 us -> 1100 us
N 971.43 hPa
internal 28.1
°
C
