TECHNICAL SPECIFICATIONS
Caring for your controller
Your controller should not be allowed to get wet or be left in excessive sunlight.
It may be cleaned regularly using a soft cloth, lightly dampened in soapy water.
Do not allow the interior of your controller to become wet. Do not use detergents,
alcohol, spray aerosols or strong solvents on your controller.
Access to the interior of the controller is not required for maintenance purposes.
If your controller is damaged, you should not use it but should return it to
SLENDERTONE
or your local distributor for replacement or repair. Repairs, service
and modifications may not be carried out by anyone other than qualified service
personnel authorised by
SLENDERTONE
.
Important: Under no circumstance should anything other than the correct type
of batteries - (rechargeable batteries 3.6V NiMH) be used with your controller.
These are available from www.slendertone.com or from
SLENDERTONE
Customer
Care.
Disposing of the gel pads and batteries
Used gel pads and batteries must never be disposed of in a fire but in accordance
with your country’s national laws governing the disposal of such items.
Accessories:
Under no circumstances should anything other than
SLENDERTONE
accessories
be used with your
SLENDERTONE
charger or
SLENDERTONE
controller (Type 390).
Any others may not be compatible with your controller and could degrade the
minimum safety levels. You can purchase all accessories www.slendertone.com
or from
SLENDERTONE
Customer Care.
SLENDERTONE ABS7
Female Belt (E:70)
SLENDERTONE ABS7
Male Belt (X:70)
SLENDERTONE ABS7
Gel Pads: • 1 large gel pad (Type 732)
• 2 small gel pads (Type 733)
SLENDERTONE BOTTOM
(E:30)
SLENDERTONE BOTTOM
Gel Pads: • 4 gel pads (Type 716)
SLENDERTONE ARMS
Accessory Female (E:60)
SLENDERTONE ARMS
Accessory Male (X:60)
SLENDERTONE ARMS
Gel Pads: • 4 gel pads (Type 715 - Female)
• 4 gel pads (Type 718 - Male)
SLENDERTONE
Belt Extension
Battery pack (3.6V, NiMH)
Battery Charger:
EU: 2504-0321 + 2504-0324 + 2504-0325; US/Japan: 2504-0322;
Australia: 2504-0321 + 2504-0327; Korea: 2504-0321 + 2504-0323
Charger complies to EN 60950, Input: nominal voltage 100-240V, frequency
50-60Hz, current 125mA. Do not use any other chargers or any other power
supplies.
Classification: Internally powered equipment, Class II charger, Type BF
applied parts.
Product Type: 390
Intended use: Muscle stimulator
Notes:
- The signal gradually increases to a peak intensity level at the start of the
contraction phase (i.e. ramp up) and gradually decreases to nothing at the start
of the relaxation phase (i.e. ramp down). When the symbol is flashing, the
stimulus is significantly reduced.
- In accordance with the laws within the member state, safety testing on the
device should be carried out every two years.
- In compliance with German law, product safety testing must be conducted
every two years by an authorised test service.
Environmental Specifications:
Operating Range: Temperature: 0 - 35°C (32 - 95°F)
Humidity: 20 - 65 % RH
Transport & Temperature Range: 0 - 55°C (32 - 131°F)
Storage Range: Humidity: 10 - 90 % RH
18
