is armed. Such as outdoor motion sensor, or any other sensors that you only want to give you
lert notification. Under such circumstances, zone(s) can be program to react only when the
red when the control panel is in security
ode.
is recommend to enable alert zone if:
This
To enabl
le
2.
.
lert Zone” setting. Notice all 5 zone LEDs, some of them
may be off, so e of them m
sh
urrent alert zone
setting.
•
If the
flashes,
s alert zone
•
If the zone LED remains steadily on, that indicates alert zone is enabled
4.
To change the setting between alert zone enable and disable, press buttons 1 to 5 will
disable alert zone feature for those zones. Pressing buttons 6 to 0 will enable alert zone
feature for those zones. Refer to
r making th
otice the status of the
zone LED cha
well.
a
control panel is in alert mode, these zones will be igno
m
It
•
You do not consider the sensors in that zone are emergency
•
Sensors in that zone are located outdoor
•
When nobody is home, you do not want to know the status of the sensors in that zone
feature was disabled for all zones at the factory.
e a rt zone feature, follow the instructions below.
1.
Press the [PROG] button on the side of the control panel, the [PROG] LED will be on.
Enter the current Master Password. Control panel will emit 3 beeps if the valid password
is entered, otherwise a single long beep will be emitted and [PROG] LED will be off.
Enter [8], which represents “A
3
m
ay flash. The LED fla ing represents the c
zone LED
that indicate
is disabled
Fig X. Afte
e change, n
nges as
Disable Alert Zone
Enable Alert Zone
Zone 1
Button [1]
Button [6]
Zone 2
Button [2]
Button [7]
Zone 3
Button [3]
Button [8]
Zone 4
Button [4]
Button [9]
Zone 5
Button [5]
Button [0]
.
You are allowed to make unlimited ch
5
anges before programming is quit. Once you are
Procee the
3.
4.
f
satisfied with the settings, press [PROG] to quit programming and the settings will be
saved.
Erase Sensor
d
followings to erase a sensor.
1.
Press the [PROG] button on the side of the control panel, the [PROG] LED will be on.
2.
Enter the current Master Password. Control panel will emit 3 beeps if the valid password
is entered, otherwise a single long beep will be emitted and [PROG] LED will be off.
Enter [9], which represents “Erase Sensor”.
Notice all 5 zone LEDs, some of them may be off, some of them may flash once, some o
the may flash twice. The LED flashing represents the occupied sensors.
