Installing the Door/Window Sensor
Window / Door Sensor is used to monitor doors or windows that open and close. When these
doors / windows are open or closed, the sensors will transmit a signal to the control panel to
notify the user. These sensors consist of 2 parts, one is the transmitter, the other is the magnet.
Remove the top cover of the sensor and insert the 3V lithium
battery to the sensor.
The transmitters should be
mounted on the door frame or
window frame by double sided
tape. The magnet should be
mounted on the door or window
by either double sided tape or
screws.
Make sure the arrow on the
magnet is aligned with the grey
marking on the transmitter.
(Show picture)
If the surface of the frame is flat enough, double-sided foam
tape is sufficient, otherwise, it is recommended to use the
mounting plate and screws as well. After mounting the
sensor, put the cover back on with the Houselink logo in the
upright position.
Try to mount the sensors as far away from the floor as possible to avoid damaging them.
Mounting the sensors at a higher position will also result in better operating range.
Do not mount the sensor to the exterior of the door / window, always mount the sensor to the
interior side of the door / window to avoid being damaged or stolen by non-intended users.
Testing:
Open the door or window to trigger the sensor, the main unit will then alert you by
visual/audio indication and voice cue.
