Note:
•
The control panel can also be armed even nobody is home, with a touch tone phone.
Please refer to “Remote Operation by Telephone”.
•
If 3 consecutive incorrect passwords are entered, alarm will sound immediately and the
control panel will be in panic mode, and start calling the emergency phone numbers.
Disarming a triggered control panel
If you hear the announcement from the control panel “System Panic” after disarming the system,
that means at least one sensor was activated which caused the alarm to sound while you were
away. Following the procedures below to set the control panel back to standby mode.
1. There will be flashing LEDs indicating the sensor(s) that triggered the alarm. You may want
to check the condition of the triggered sensor(s), the sensor(s) may be damaged if there
were break-ins.
2. You need to reset the sensor by manually triggering it twice, i.e. open and close a door /
window sensor, or walk in front of the motion sensor. The LED representing that sensor will
then stop flashing.
3. You must now enter the password again on the control panel
or press the button 3 of the
keychain remote
, as an acknowledgement of the alarm event. This will set the control panel
back to standby mode.
Note: The control panel can also be disarmed even nobody is home, with a touch tone phone.
Please refer to “Remote Operation by Telephone”
Disarming under Duress
If you are forcibly compelled to disarm the control panel, you may enter the Duress Password.
Entering the duress password will stop the siren from sounding but the control panel will silently
call the emergency phone numbers for help. The called party will hear the voice announcement
“System Panic”.
Panic
Pressing the panic button will cause the siren to sound and outgoing calls will be made to the
preprogrammed phone numbers, “System Panic” will also be announced. This can be used in
any emergency situation. You can also press the panic button on the keychain remote to
perform the same function.
To stop the siren, user can enter either the Master Password, or the Secondary Password. You
can also press button 3 on the keychain remote to perform the same function. This will
terminate both the siren and the control panel from calling the rest of the emergency phone
numbers.
