Skyjack 6826El, Руководство по эксплуатации

Страница: 35 / 47

SKYJACK, Page 35
April 2006
SJIII Series E - CONVENTIONALS
Section 2 - Operation Battery Maintenance
When changing the input voltage wait until all the
LEDs are OFF or wait a minimum of 20 seconds
before switching on the new voltage.
3. The charging time is affected by numerous factors
including battery Amp-Hour capacity, depth of
discharge, battery temperature, and battery
condition (new, old or defective). Batteries larger
than 240 Ah can be recharged but will take longer.
Do not disconnect the DC output wires near the
batteries when the charger is ON. The resulting
arcing could cause the batteries to explode.
If the charger must be disconnected, first disconnect
the AC power supply cord
from its outlet, then disconnect the
charger DC connections.
Risk of an electric shock. Do not touch un-insulated
parts of the charger output wires, battery connector,
or battery terminals.
Visually and manually inspect to verify the DC output
wires and terminals are in good working condition
before each use.
4. The charger will start automatically within four to
six seconds. The charger will start even with severely
discharged batteries (down to 1V terminal voltage).
Once charging starts, the LEDs indicate the charging
progress.
Caution
Danger
Danger
Danger
Charging State LED
The charger goes into an equalizing charge mode after
the batteries are charged and all 3 LEDs are “ON”. The
charger will continue to charge at a low current then
shut-off automatically when complete.
If all 3 LEDs blink together, there is a problem.
Take proper action according to the following
instructions:
3 LEDs blink once simultaneously :
Output connection error. Check the battery and
charger connection. The output may not be
connected to the batteries or the connections to
the batteries may have corroded or loosened. The
output may be shorted due to improper connection
to the batteries or pinched wires. The output may
be connected in reverse polarity to the batteries.
The charger is not damaged by any of these
problems.
3 LEDs blink twice simultaneously :
The charger is indicating that the AC voltage is too
low or too high. Check the AC input voltage.
3 LEDs blink three times simultaneously :
Charger is overheated. No action required. When
the charger cools, charging will re-start
automatically. Check and correct for dirt or other
debris on charger that may be reducing cooling.
3 LEDs blink four times simultaneously :
Input or output over current. No action required,
charger will correct and re-start automatically.
100% LED lamp blinks:
Charger 18 hour timer has timed out due to battery
problem.
State of charge 1 ST LED 2 ND LED 3 RD LED
0 to 50% Blinking Off Off
50% to 75% On Blinking Off
75% to 100% On On Blinking
100% On On On
60133AA