Skyjack 6826El, Руководство по эксплуатации

Страница: 16 / 47

April 2006
SKYJACK, Page 16 SJIII Series E - CONVENTIONALS
Section 2 - Operation Component Identification
2.2-4 Base Controls
This control station is located in the hydraulic/electric
tray. It contains the following controls:
Figure 2-2. Electrical Panel
1. Buzzer Alarm - This audible pulse alarm sounds
when platform is being electrically lowered. On
machines with certain options, this alarm sound
when any control function is selected.
2. Hourmeter - This gauge records the accumulated
time of operation of the aerial platform.
3. Circuit Breaker Resets - In the event of a power
overload or positive circuit grounding, the circuit
breaker will pop out. Push the breaker back in to
reset.
4. Platform UP/DOWN Toggle Switch - This toggle
type switch raises or lowers the platform to a
desired height.
5. Enable Switch - This switch, when activated,
brings power to the UP/DOWN toggle switch.
2.2 Component Identification
The following descriptions are for identification,
explanation and locating purposes only.
2.2-1 Emergency Main Power Disconnect Switch
Emergency Main Power Disconnect Switch - This
switch is located at the rear of the base.
Figure 2-1. Emergency Main Power
Disconnect Switch
1. Emergency Main Power Disconnect Switch -
This switch, when in “OFF” position, disconnects
power to all circuits. Switch MUST be in “ON”
position to operate any circuit.
2.2-2 Motion Alarm
The aerial platform is equipped with a motion alarm.
The alarm produces an audible sound accompanied
by the amber light (if equipped) when any control func-
tion is selected.
2.2-3 Tilt Alarm
The aerial platform is equipped with a device which
senses when the machine is out of level in any direction.
When activated, it disables drive and lift functions of
the aerial platform and an alarm produces an audible
sound accompanied by the amber light (if equipped).
This alarm activates once every 1.5 seconds. Lower
platform completely, then reposition machine so that
it is level before raising platform.
Note
If the tilt alarm sounds and the platform does not,
or only partially raises, immediately lower the
platform and ensure that the machine is on a firm
LEVEL surface.
1
1
1
3
2
4
5