WARNING
Observe the following instructions for lifting the vehicle.
■
If the wheel has to be changed on a slope, first of all block the opposite
wheel with a stone or similar object to prevent the vehicle from unexpectedly
rolling away.
■
Secure the base plate of the lifting jack with suitable means to prevent pos-
sible moving. A soft and slippery ground under the base plate may move the
lifting jack, causing the vehicle to fall down. It is therefore always necessary to
place the lifting jack on a solid surface or use a wide and stable base. Use a
non-slip base (e.g. a rubber foot mat) if the
surface is smooth
, such as cobbled
stones, tiled floor, etc.
■
Only attach the lifting jack to the attachment points provided for this pur-
pose.
■
Always raise the vehicle with the doors closed.
■
Never position any body parts, such as arms or legs under the vehicle, while
the vehicle is raised with a lifting jack.
■
Never start the engine when the vehicle is raised – risk of injury.
CAUTION
■
The prescribed tightening torque of the wheel bolts for steel and light alloy
wheels is 120 Nm.
■
If the wheel bolts are fastened too tightly, this can cause damage to the anti-
theft wheel bolt and the adapter.
Note
■
The anti-theft wheel bolt set and adapter can be purchased from a ŠKODA Part-
ner.
■
The national legal requirements must be observed when changing a wheel.
Preliminary work
First read and observe the introductory information and safety warn-
ings on page 177.
Always change a wheel on a level surface as far as possible.
The following steps must be carried out before actually changing the wheel:
›
Let
all of the occupants get out.
While changing a tyre, the occupants of the
vehicle should not stand on the road (instead they should remain behind a crash
barrier).
›
Switch off the engine.
›
Move the gearshift lever into
Neutral
or move the selector lever for the auto-
matic gearbox into position
P
.
›
Firmly apply the
handbrake
.
›
If a trailer is connected, uncouple it.
›
Remove the
vehicle tool kit
» page 177
and the
spare wheel
» page 172
,
Spare
wheel
from the boot.
Changing a wheel
First read and observe the introductory information and safety warn-
ings on page 177.
›
Remove the full wheel trim
» page 173
or caps
» page 173
.
›
In the case of light alloy wheel rims remove the wheel trim cap
» page 174
.
›
First of all slacken the anti-theft wheel bolt and then the other wheel
bolts
» page 179
.
›
Jack up the vehicle until the wheel that needs changing is clear of the
ground
» page 180
.
›
Unscrew the wheel bolts and place them on a clean surface (cloth, paper, etc.).
›
Remove the wheel.
›
Attach the spare wheel and slightly screw on the wheel bolts.
›
Lower the vehicle.
›
Alternately tighten the wheel bolts opposite each other using the wheel
wrench (crosswise) and then tighten the anti-theft wheel bolt
» page 179
.
›
Reinstall the wheel trim/wheel trim cap or the caps.
WARNING
■
All bolts must be clean and must turn easily.
■
Under no circumstances grease or oil the wheel bolts!
■
When fitting unidirectional tyres, ensure that the direction of rotation is cor-
rect
» page 169
.
178
Do-it-yourself
Содержание 2013 Roomster
Страница 1: ...SIMPLY CLEVER ŠKODA Roomster Owner s Manual ...
Страница 8: ...Fig 1 Cockpit 6 Using the system ...
Страница 212: ......
Страница 213: ......