Lock cap
Release pin
Key
Locking ball
Note
■
The tool for removing the wheel trim is part of the vehicle tool kit
» page 177
.
■
If you lose the key, please get in touch with a specialist garage.
Adjusting the ready position
Fig. 106
Setting the ready position/ready position
First read and observe the introductory information and safety warn-
ings on page 117.
Always adjust the ball head to the correct position before fitting.
›
Turn the key so that its red mark
1
» Fig. 106
is visible.
›
Grip the ball head below the protective cap
2
.
›
Press the release pin
3
as far as the stop in the direction of the arrow - at the
same time push the lever
4
downwards as far as it will go in the direction of
the arrow.
The lever remains locked in this position.
CAUTION
In the ready position, the key cannot be removed nor turned to a different posi-
tion.
8
9
10
11
Fitting the ball head
Fig. 107
Insert the ball head/lock the lock, and put the lock cover on
First read and observe the introductory information and safety warn-
ings on page 117.
›
Remove the cover in the rear bumper
2
» Fig. 104
on page 117 in the direction
of the arrow using the tool for removing the wheel trims.
›
Pull off the cover for the mounting recess
4
» Fig. 104
on page 117 in the direc-
tion of the arrow
»
.
›
Adjust the ball head to the ready position
» page 118
.
›
Grip the ball head
from underneath
» Fig. 107
and insert into the mounting re-
cess until it is heard to latch
»
.
Lever
1
» Fig. 107
automatically
turns upwards and the release pin
2
pops out
(its red and green parts are visible)
»
.
If the lever
1
does not turn automatically, or if the release pin
2
does not pop
out, remove the ball head from the mounting recess by turning the lever down-
wards as far as it can go. Clean the tapered surfaces on the ball head and the
mounting recess.
›
Lock the lock on the operating lever by turning the key by 180° to the right (see
green marking
3
is visible) and remove the key in the direction of the arrow.
›
Push the cap
4
» Fig. 107
onto the lock in the direction of the arrow
»
.
›
Check the ball head for secure mounting
» page 119
.
118
Driving
Содержание 2013 Roomster
Страница 1: ...SIMPLY CLEVER ŠKODA Roomster Owner s Manual ...
Страница 8: ...Fig 1 Cockpit 6 Using the system ...
Страница 212: ......
Страница 213: ......