Function
Fig. 103
Centre console: Button for the
START-STOP system
First read and observe the introductory information and safety warn-
ings on page 114.
The START-STOP system helps you to save fuel while at the same time reducing
harmful exhaust emissions and CO
2
emissions.
The function is automatically activated each time the ignition is switched on.
In the start-stop mode, the engine automatically switches to the vehicle's idle
phase, e.g. when stopped at traffic lights. The engine restarts automatically
where necessary.
Information regarding the current state of the START-STOP system is indicated in
the display of the instrument cluster.
Automatic engine shut down (stop phase)
›
Stop the vehicle (where necessary, apply the handbrake).
›
Take the vehicle out of gear.
›
Release the clutch pedal.
Automatic renewed engine restart (start phase).
›
Depress the clutch pedal.
Switching the START-STOP system on and off
The START/STOP system can be switched on/off by pressing the
» Fig. 103
but-
ton.
When start-stop mode is deactivated, the warning light in the button lights up.
If the vehicle is in the stop phase when manually switching off the system, the
engine starts immediately.
The START-STOP system is very complex. Some of the procedures are hard to
check without servicing. The general conditions for the proper functioning of the
START-STOP system are listed in the following overview.
Conditions that must be completely met for automatic engine switch-off (stop
phase)
›
The gearshift lever is in Neutral.
›
The clutch pedal is not depressed.
›
The driver has fastened the seat belt.
›
The driver's door is closed.
›
The bonnet is closed.
›
The vehicle is at a standstill.
›
The factory-fitted towing device is not electrically connected to a trailer.
›
The engine is at operating temperature.
›
The charge state of the vehicle battery is sufficient.
›
The stationary vehicle is not on a steep slope or a steep downhill section.
›
The engine speed is less than 1 200 rpm.
›
The temperature of the vehicle battery is not too low or too high.
›
There is sufficient pressure in the braking system.
›
The difference between the outdoor- and the set temperature in the interior is
not too great.
›
The vehicle speed since the last time the engine was switched off was greater
than 3 km/h.
›
No cleaning of the diesel particle filter takes place
» page 22
.
›
The front wheels are not turned excessively (the steering angle is less than 3/4
of a steering wheel revolution).
The automatic re-start (start phase) takes place in each of the following
interventions:
›
The clutch is depressed.
›
The max./min. temperature is set.
›
The defrost function for the windscreen is switched on.
›
A high blower stage has been selected.
›
The START STOP button is pressed.
The automatic re-start takes place in each of the following situations, without
intervention from the driver:
›
The vehicle moves at a speed of more than 3 km/h.
›
The difference between the outdoor- and the set temperature in the interior is
too great.
›
The charge state of the vehicle battery is not sufficient.
›
There is insufficient pressure in the braking system.
115
Assist systems
Содержание 2013 Roomster
Страница 1: ...SIMPLY CLEVER ŠKODA Roomster Owner s Manual ...
Страница 8: ...Fig 1 Cockpit 6 Using the system ...
Страница 212: ......
Страница 213: ......