Sirona inLab MC XL, Руководство по установке

Страница: 28 / 88

62 38 328 D3439
10 D3439
.
092.05.03
.
02 04.2010
Installing the manual block clamp Sirona Dental Systems GmbH
Installing the block fastener Installation Instructions for Manual Block Clamp CEREC MC XL, inLab MC XL
4.5
Installing the block fastener
The new block fastener can be distinguished from the old one by its circum
-
ferential external groove.
The retaining ball (A) is pressed outward when the setscrew (B) is screwed
in.
The projection (C) of the block fastener must be installed in the 9 o'clock
position.
1. Install the new block fastener in the block shaft. Use the block fastener
installation aid (see "Toolkit" [ 5]).
2. Tighten the block fastener (B) securely with the installation aid pressed.
3. Check the block fastener for a firm fit by pulling on the installation aid.
4.6
Checking the block fastener
1. Insert a material block in the block clamp and fasten it (see Using a ma
-
nual block clamp [ 14]).
2. Check whether a gap is visible between the block holder and the block
clamp.
Ç
If no gap is visible, the block fastener was installed correctly.
NOTICE
Gap between block holder and block clamp
If a gap is visible, the block is seated too high axially.
Correct the fit of the block fastener.