Sirona inLab MC XL, Руководство по установке

Страница: 26 / 88

62 38 328 D3439
8 D3439
.
092.05.03
.
02 04.2010
Installing the manual block clamp Sirona Dental Systems GmbH
Preparing the thread lock and the installation tool Installation Instructions for Manual Block Clamp CEREC MC XL, inLab MC XL
4.2
Preparing the thread lock and the installation tool
inLab
1. Apply three drops of Loctite 243 to the outer thread of the block shaft.
2. Screw the block clamp (B) up and down to spread the adhesive over the
thread.
3. Check to make sure the adhesive is properly distributed.
4. Slide the block clamp (B) onto the shaft key (E).
5. Twist the block clamp so that the threaded opening for the ball pressure
screw is located above the slot of the shaft key.
6. Tighten the locking screw (C) as far as it will go.
Ç
The shaft key is radially aligned to the block clamp, however, can be
adjusted slightly axially.
7. Use the shaft key to slide the block clamp into the installation tool (F) . In
doing so, note the positions of the pushers (D).
4.3
Preparing the milling unit
CEREC
1. Connect the power plug and switch the milling unit on at the main switch
(I).
2. The block axle automatically travels to the block change position
3. Switch the milling unit off at the main switch (0) and disconnect the power
plug.
NOTICE
Adjusting washer for inLab
Mount the adjusting washer (A) on the block shaft and place it on top of the
end of the bellows.