90
Data size
：
16bit
Display mode
：
Decimal system
Parameter function
：
Set the alarm threshold for the overload of the driver, the reference is the rated current of the servo motor.
The driver has overload protection function, in accordance with the driver rated current 110% to generate the overload curve, but this situation
will be directly into the fault state. This parameter can be set to drive overload alarm threshold, once the driver is detected overload is greater
than the set value, that is, a driver overload warning ALE04, but will not stop running.
P8-13
Motor overload warning settings
Initail value
Unit
Communication
Address
80
%
280DH
Control Mode
：
P S T
Range
：
20
～
100
Data size
：
16bit
Display mode
：
Decimal system
Parameter function
：
Setting the alarm threshold for the overload of the servo motor, the reference is the rated current of the servo motor.
Motor overload protection function, according to 120% of the servo motor rated current began to generate overload curve, but this situation will
be directly into the fault state. This parameter can set the motor overload alarm threshold, once detected motor overload is greater than the set
value, that is, the motor overload warning ALE03, but will not stop running.
P8-14
S-ON condition selection of each
parking mode
Initail value
Unit
Communicatio
n Address
0
-
280EH
Control Mode
：
P S T
Range
：
0
～
1
Data size
：
16bit
Display mode
：
Decimal system
Parameter function
：
More are available at P8-17 Parameter function explanation
P8-15
S-ON
condition
Initail value
Unit
Communication
Address
3
-
280FH
Control Mode
：
P S T
Range
：
0
～
3
Data size
：
16bit
Display mode
：
Decimal system
Parameter function
：
More are available at P8-17 Parameter function explanation
P8-16
After the S-OFF S-ON effective required
interval
Initail value
Unit
Communication
Address
5.00
S
2810H
Control Mode
：
P S T
Range
：
0.01
～
300.00
Data size
：
16bit
Display mode
：
Decimal system
Parameter function
：
More are available at P8-17 Parameter function explanation
P8-17
S-ON effective speed setting
Initail value
Unit
Communication
Address
20
rpm
2811H
Control Mode
：
P S T
Range
：
20
～
motor rated speed
Data size
：
16bit
Display mode
：
Decimal system
Parameter function
：
After the S-OFF setting S-ON condition, first setting the parking mode (P1-53), and then select whether to set S-ON
condition on zero speed parking (P8-14, free parking must comply with S-ON condition), last set S- ON condition. When setting these
conditions we must shut down, and effect immediately.
0 Zero speed parking
does not comply with
1 Zero speed parking
compliance
Start according to P8-16 time condition
Start with P8-17 speed condition
Start with P8-16 time condition and P8-17 speed condition
0
free parking
1
Zero speed parking
No conditions, can be started immediately
P1-53
P8-14
P8-15
0
1
3
2
As shown following, different settings, S-ON region is not the same, different settings in P8-15: