SimonsVoss SI:SmartHandle Series, Руководство пользователя, Страница: 39 / 160

4. Outer fitting
5. handle fastener piece
6. Door lock (not included in the scope of supply)
7. Snap-in mechanism
8. Inside fitting
9. Screw
10. Inside handle
11. Inside hexagon screw
12. Inlay
13. Inlay
Installation:
1. Optional: handles, escutcheons, fittings and other door furniture fitted
to the door are to be removed.
2. Optional: Fasten mortise lock into the door
3. SmartHandle is partly assembled when delivered; see Disassembly.
4. The inlay cannot be fitted on some handles, such as offset handles,
when they are already installed. Push the inlay onto the outer handle
with the logo facing outwards in such cases. You can do this with most
handles.
5. Push inlay (1) onto the outer handle (3). Depending on the handle
model, it may not be possible to fit it once the handle is installed.
6. Insert outer handle (3) horizontally into the outer fitting (4), placing it in
the direction that you require, depending on whether it is a DIN left-hand
or right-hand door.
7. Place handle fastener piece (5) into position (see Diagrams 2 and 3).
8. Hold the outside handle (3) and use the spanner to rotate the fastener
piece (5) about 75° to the right until it fits into position (Diagrams 4 and
5). If you do not fit it correctly, the handle may come loose again.
9. Optional: In a lock with an 8.5 mm or 10 mm spindle, push the corres-
ponding sleeve (8 mm --> 8.5 mm [not included in the supply package]
or 8 mm --> 10 mm) through the retainer opening in the mortise lock
from the inside.
10. Push the 3-pole inside fitting cable into the snap-in mechanism (7). This
protects it from external impact during installation (Diagram 6).
11. The inside fitting (8) is mounted onto the inner surface of the door. The
inside fitting (8) is fastened to the door by sliding the spindle through
the retainer slot and the snap-in mechanism through the mortise lock
(6) cylinder opening at the same time.
SmartHandle SmartIntego (Manual)
8. Installation (manual)
39 / 160