SimonsVoss SI:SmartHandle Series, Руководство пользователя

Страница: 41 / 160

31. Push the cover (2) onto the outer fitting (4), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 10).
32. Push the inlay (1) over the handle (3) and click it into place in the cover.
8.1.5 Snap-in WP
1. Optional: handles, escutcheons, fittings and other door furniture fitted
to the door are to be removed.
2. Optional: Fasten mortise lock into the door
3. SmartHandle is partly assembled when delivered; see Disassembly.
4. The inlay cannot be fitted on some handles, such as offset handles,
when they are already installed. Push the inlay onto the outer handle
with the logo facing outwards in such cases. You can do this with most
handles.
5. Push inlay (1) onto the outer handle (3).
6. Insert outer handle (3) horizontally into the outer fitting (4), placing it in
the direction that you require, depending on whether it is a DIN left-hand
or right-hand door.
7. Place handle fastener piece (5) into position (see Diagrams 2 and 3).
8. Hold the outside handle (3) and use the spanner to rotate the fastener
piece (5) about 75° to the right until it fits into position (Diagrams 4 and
5). If you do not fit it correctly, the handle may come loose again.
9. Optional: In a lock with an 8.5 mm or 10 mm spindle, push the corres-
ponding sleeve (8 mm --> 8.5 mm [not included in the supply package]
or 8 mm --> 10 mm) through the retainer opening in the mortise lock
from the inside. The 8.5 mm sleeve is not included in the supplied pack-
age.
10. Push the cable from the outer fitting through the profile cylinder/Swiss
Round/British Oval opening in the mortise lock (6) from the outer side.
11. Then insert the inside fitting (8) by pushing the spindle through the re-
tainer slot at the same time. Also push the snap-in mechanism through
the cylinder opening in the mortise lock (6) and through the door, so
that it is flush with the door. Ensure you do not catch or buckle the cable
while doing so.
12. Then push the outer fitting (4) spindle slot onto the inside fitting spindle
while pushing the snap-in mechanism (7) on the outside fitting into the
snap-mechanism (7) on the inside fitting, so that the fitting is flush with
the door.
13. Press outer and inside fittings together, so that they are both flush
against the door.
SmartHandle SmartIntego (Manual)
8. Installation (manual)
41 / 160