Simex MultiCon CMC-99/141, Руководство пользователя

Страница: 253 / 332

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
◦ if the Output list is empty, press the sign '+' to add the output channel
(if the list has defined the output channels, use the arrows in the upper right
corner to select the input channels),
◦ Output active parameter set as yes ,
◦ Control type parameter set as as a linear output ,
◦ in
Output register
submenu:
– in
Register number
parameter write
1h
,
– Data format parameter set as 32 bits, float (this depends on
the register format in the Slave device),
– 32-bit reading parameter set as two 16-bit registers ,
– Ordering parameter set as CDAB , because first the younger word part
is sent (Register 1h), then the older part (Register 2h),
◦ press the sign
'+'
and then:
◦
Output active
parameter set as
yes
,
◦ Control type parameter set as as a relay ,
◦ in Output register submenu:
– in Register number parameter write 4h ,
– Data format parameter set as 16 bits, unsigned (this depends on
the register format in the Slave device),
– in
Data mask
parameter write
0x0001
,
– in Data shift parameter write 0 ,
◦ press the sign '+' and then:
◦ Output active parameter set as yes ,
◦ Control type parameter set as as a relay ,
◦ in
Output register
submenu:
– in
Register number
parameter write
8h
,
– Data format parameter set as 16 bits, unsigned (this depends on
the register format in the Slave device),
– in Data mask parameter write 0x0001 ,
– in Data shift parameter write 0 ,
•
Blocks config.mode
parameter set as
manual
,
• in
Block list
submenu:
◦ Block type parameters set as write HOLDING reg. ,
◦ Register size parameter set as 16-bit registers (according to register
format in the Slave device),
◦ in First register parameter write 1h ,
◦ in
Last register
parameter write
2h
,
◦ create next block by pressing
'+'
sign,
◦
Block type
parameter set as
write HOLDING reg.
,
◦ Register size parameter set as 16-bit registers (according to register
format in the Slave device),
◦ in First register parameter write 4h ,
◦ in
Last register
parameter write
4h
,
◦ create next block by pressing
'+'
sign,
◦
Block type
parameters set as
write HOLDING reg.
,
◦ Register size parameter set as 16-bit registers (according to register
format in the Slave device),
◦ in First register parameter write 8h ,
◦ in Last register parameter write 8h ,
• move to the
Device templates
parameter block and press
253