User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
Fig. 7.107. Sample of Profile/timer configuration
Comments to the
Looping
parameter
If the user selects:
counted
or
infinite
repeats of the Profile/timer, the user has two
alternatives:
–
if the section from which begins the next repeat Profile/timer is a
ramp
, then in the
whole duration of this section is linear generating the output signal from the
final value
of the previous section to
final value
of this section. This is shown in
(dashed line-run profile)
–
if the section from which the next repeat of the Profile/timer begins is a constant
value, then Profile signal quickly transient (0.1 seconds)from the
final value
of the
previous section to a
constant value
in this section. This is shown in
(profile guided fine line).
190
Definition of parameters
1
2
3
4
5
6
