IP-7900-02/-03/7700-02/03 Advanced Operation Guide
8
4
Insert a cut-sheet media into the paper feeder
slot.
Insert the cut-sheet media so that the media feed
sensor is covered with the media.
5
Suppy side
Set the pressure to “Normal” by rotating the
pressure control knob.
Point to be checked again
- Check that the media on the platen is not lifted
up or wrinkled.
6
With pressing the media
edge guard’s your side part,
move each media edge
guard.
Align each media edge
guard’s notch with the
media edge.
(1)
(2)
Notch
Set the media edge guards.
(1) With pressing the media edge guard’s your side part,
move each media edge guard to the media edge.
(2) Align each media edge guard’s notch with the
media edge.
Check that:
The media edge guards are not under the media.
The thick media, being inserted forcibly, is not jammed
under the media edge guards.
CAUTION
- To prevent a media jam, be sure to apply the media
edge guards to prevent a media jam.
-
-
7
Close the front cover, and then install the
protection bar.
8
C H E C K E D G E G U A R D
[
O K ?
Press the
key.
