Sierra InnovaMass 240i Series, Инструкция по эксплуатации, Страница: 68 / 115

68
Totalizers are used to monitor accumulated flow, often for billing and cost allocation purposes.
The totalizer sub-menu is used to turn the totalizer ON or OFF, to reset, and to tell the meter
when to send out a totalizer pulse and what that pulse should look like.
Table 10: Totalizer Sub-Menu
Totalizer (Sub-Menu): Reset Totalizer
Use this menu to reset the totalizer to zero. From the Totalizer (Sub-Menu) screen press enter

and you will see a screen like this:
Pressing enter

again will show a flashing “Yes”. The screen will look like this:
Use the up

and down


keys to toggle between “Yes” and “No”. Make your selection and
then press enter

to finalize the selection and be automatically sent back to the Totalizer (Sub-
Menu).
Totalizer Sub-Menu: Reset Pulse Count
From the Totalizer Reset screen press


to move to the Reset Pulse Count menu. If you need to
actually set up the totalizer (rather than just reset it to zero), navigate to the Unit per pulse screen.
Use Table 10 above for guidance.
Use this menu to reset the pulse counter. The pulse count is the count of pulses that went to the
pulse relay since the last reset. This count will match your external counter if they were both reset
at the same time and can be used to verify an external counter. Pulse count X units per pulse=
totalizer count /- 1 units per pulse value.
In the example below, there were 349 pulses since the last reset.
Reset Totalizer
Reset Pulse Cnt.
349
Reset Totalizer
Yes