Parame‐
ter ID
Parameter name on
the display
Meaning
13
LOOP TEST
Loop test
14
TRIM INPUT 1
One-point calibration input 1
15
TRIM INPUT 2
One-point calibration input 2
16
CHANGE PIN
Change User PIN
17
PIN RECOVERY
PIN recovery
18
USER PIN
Enable and disable User PIN
19
MIN INPUT 1
Minimum measured peak value at Input 1
20
MAX INPUT 1
Maximum measured peak value at input 1
21
MIN INPUT 2
Minimum measured peak value at input 2
22
MAX INPUT 2
Maximum measured peak value at Input 2
23
MIN ETEMP
Minimum transmitter electronics temperature
24
MAX ETEMP
Maximum transmitter electronics temperature
25
BUTTON LOCK
Enable and disable button lock
The parameter ID is written after the parameter name in parentheses from here on out. Example:
Parameter "Damping value" [11].
Navigating in the parameter view
Requirement
The button lock is disabled.
Disabling button lock (Page 158)
Procedure
1. Use the
or
buttons to navigate within the parameters.
To navigate faster, keep the or
button pressed.
After the last parameter, you jump to the first parameter, and vice versa.
2. To switch to edit view, press the button.
3. To return to the measurement view, press the button.
7.1.2.4
Edit view
You change the parameter values in the edit view. Wizards are available for specific parameters.
Parameter values
There are various parameter values:
• Enumerations (e.g. unit type)
• Numerical values (e.g. damping)
Operating (SITRANS TF)
7.1 Local operation
SITRANS TH100/TH320/TH420/TR320/TR420/TF320/TF420 with 4 to 20 mA/HART
110
Operating Instructions, 05/2020, A5E41864807-AB